€ 44,00 tax incl.
Victron Energy PWM Bluesolar 10A 12/24V charge controller with LCD display and USB ports
9 Item Items
Warning: Last items in stock!
|Technology (MPPT - PWM)||PWM|
|Nominal system voltage (VDC)||12 / 24 VDC Auto work|
|Rated Battery Current||10A|
Are you a dealer or installer?
For bulk purchase of Victron Energy products called the n. 0882 228247, or write to [email protected]
BlueSolar PWM Charge Controller 12/24V 10A
Liquid crystal display and USB outputs
Liquid crystal display
For status monitoring and set-up
Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage.
Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed, please see the manual. The connect and disconnect voltages are adjustable.
Day/night timing of the load output
This option allows for a pre-set ON-time after dusk.
• Always connect the battery first, in order to allow the Controller to recognize system voltage.
• Use a 12V (36 cells) solar array for a 12V system.
• Use a 24V (72 cells) solar array for a 24V system.
Programmable battery charge algorithm
Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)
Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A
Product code: SCC010010050
Battery Voltage: 12/24V with automatic system voltage detection
Rated charge current: 10A
Maximum solar voltage : 28/55V
Dimensions (h x w x d): 96 x 169 x 36mm
29 other products in the same category: